PRODUCTS

CANDORR 2150SR POLYESTER
RESIN (360ML)

CANDORR 2150SR Chemical Anchoring Cartridge is a two component, specialized Polyester based resin supplied in cartridges. This is extensively utilized in the construction industry, and is ideally suitable for column, floor, and concrete walls among others. Candorr 2150SR comes in 8:1 ratio for the best results and is a 360ml cartridge. It is highly preferred in various constructions, infrastructures and industrial applications.
GET IN TOUCH

Applications -

  • Anchoring installation for new construction where steel bar or bolts are not pre- embedded
  • Reconstruction of old buildings, column expanding and others
  • Best used with Candorr STO49 Caulking Gun
  • Fixing reinforcement bars and threaded steel rods for Constructions, Infrastructures, Steel Structures, Industrial Machines, handrails, steel plates etc.
  • Used for Medium to High load applications

Features -

  • Strong adhesion. High Pull-Strength
  • Quick setting and curing time
  • Easy Installation & quick use
  • Most suitable for dry conditions
  • Broad temperature for processing, from -5 degree Celsius to 40 degree Celsius
  • No sagging for ceiling and vertical wall anchoring installation
  • Excellent Thixotropic property leads to best in class Gel time and makes it good for all types of substrates such as Concrete, Rock, AAC, ALC, Red Brick or hollow material Reduced anchor spacing and edge distance
  • Excellent bonding with concrete and steel bar
  • No pressing against concrete, pull strength higher than embedded steel
  • Partially used cartridges can be re-used by replacing the mixer nozzle

Cartridge Installation Guide -

  • Open top of cartridges
  • Remove red stopper from the cartridge top and attach the mixing nozzle, please screw down tight
  • Pull the injector out from the Caulking gun Candorr STO49, at maximum range
  • Install the cartridge on gun properly
  • Dispense 2-3 trigger pulls of adhesive to waste until color is grey, with no streaks

Chemical Installation Guide -

  • Drill hole on substrate to the depth required
  • Essentially clean holes with brush or blower & blow out all the dust completely
  • Insert anchoring chemical into the hole as per formula
  • Insert reinforced bar/ threaded rod with rotary action
  • Allow adhesive to cure for the specified time